Some Warm Tips of Gens Ace Lipo Batteries

Lithium Ion and Lithium Polymer battery chemistries cannot be overcharged without damaging active materials. The electrolyte breakdown voltage is precariously close to the fully charged terminal voltage, typically in the range of 4.1 to 4.3 volts/cell. Therefore, careful monitoring and controls must be implemented to avoid any single cell from experiencing an overvoltage due to excessive charging.

Single lithium-based cells require monitoring so that cell voltage does not exceed predefined limits of the chemistry. Series connected lithium cells pose a more complex problem: each cell in the string must be monitored and controlled. Even though the pack voltage may appear to be within acceptable limits, one cell of the series string may be experiencing damaging voltage due to cell-to-cell imbalances.

Gens ace 2 cell lipo battery

Gens ace 2 cell lipo battery

Now the following are the 2 cell 1s lipo battery from Genstattu.com

Gens ACE 3300mAh Power Cell LiPo packs are ideal for all Rustler, Stampede, Bandit, and Monster Jam models. Power Cell LiPo packs are engineered to give the punch and on-demand power to reach the top speeds RC models are built to achieve. Premium LiPo cells developed specifically for Traxxas feature oversized discharge tabs for maximum efficiency. The cells are hard-wired with 12-gauge Maxx® Cable, eliminating the resistance and power-loss associated with plug-in wires. The standard XH plug permits balance charging with the #2933 EZ-Peak Plus LiPo/NiMH charger, and the Traxxas High-Current Connector assures total power transfer for higher speeds, longer run time, and more fun from every charge. The packs’ semi-rigid construction results in a firm, rugged, and compact pack that does not require a hard case, and the center-wire configuration assures a pinch-free fit in Traxxas vehicles. Covered under Gens ACE’ Lifetime Battery Exchange Program. Except 2 cell lipo rc batteries, we also suppy 1s lipo battery, 3s lipo battery, 4s lipo battery, and so on. Our Lithium Polymer batteries hold a large amount of energy and must be respected. Discharging or charging at an improper rate will cause excessive heat which can damage the battery, or even cause a fire!

Handling:
Do not expose the battery to excessive physical shock or vibration. Short circuiting should be avoided, however, accidental short circuiting for a few seconds will not seriously affect the battery. Prolonged short circuits will cause the battery to rapidly lose energy, could generate enough heat to burn skin, and may cause the safety release vents of the enclosed cells to open. Sources of short circuits include jumbled batteries in bulk containers, coins, metal jewelry, metal covered tables, or metal belts used for assembly of batteries in devices. To minimize risk of short circuiting, the protective case supplied with the battery should be used to cover the terminals when transporting or storing the battery.

Do not disassemble or deform the battery. Should an individual cell within a battery become ruptured, do not allow contact with water. If soldering or welding to the battery is required, consult your Energizer Battery Manufacturing, Inc.representative for proper precautions to prevent damage to the i

Charging:

This battery is made to be charged many times. Use an Energizer approved battery charger. Never use a modified or damaged battery charger. Do not charge for over 180 minutes or repeat charging without intermittent discharging. A backup charge termination based on time is recommended to prevent overcharging. The charging temperature should be between 0°C and 50°C (32°F and 120°F). The battery pack will normally warm during charging.

Charging Voltages and Currents:

Charging voltages are prevented from exceeding the specified limits by an internal battery protection circuit. Never use a battery which shows signs of a damaged protection circuit or broken case. (Such damage to the protection circuit may be indicated by voltages at the battery terminals outside of their specified ranges.) Adhere to all specified charging and discharging voltages and currents. Do not use battery if its voltage drops below the specified minimum voltage

By complying with the requirements specified above, Lithium Batteries are not otherwise regulated as Dangerous Goods. Lithium Batteries manufactured, packaged and shipped by Energizer Battery Manufacturing, Inc. meet the requirements specified above. Any Lithium Batteries subsequently repackaged or reshipped are required to meet all of the requirements specified above.





Dejar un comentario